2 Reclaimed Brass & Iron Cheval Mirror Bolt Swing/Tilt /Chest Furniture Hardware

Description

This is a pair of Cheval mirror bolts. These would be used to go through the wooden harps that are on the outside of the mirror, then into the mirror frame to allow it to swing, or tilt / lean. This comes with 2 bolts as shown, solid fancy brass thumb twist head attached to heavy iron machine screw, each bolt comes with 2 pieces on to attach to the outside of the mirror (which then will have a hole behind it to allow the bolt to slide through, snug) and the back piece on the end attaches to the actual mirror frame (again with a hole behind it to allow the bolt to slide through) you then tighten the bolt into this piece which pulls the mirror from each side till it is tight, meaning you can tilt it and it wont swing. The total length is 4" long keep in mind you can cut down the bolt at the end if its abit too long. The thumb twist (brass) measures 1" from below the ball to top and 1 1/8" across. The small brass exterior slide through measures 1" long by 1/2" the larger screw on end (which also gets screwed into the actual mirror and allows the bolt to thread in to tighten) measures 1 1/4" across by 1/2"
Please note you will receive 2 of these bolts each with 2 components you see on them in pics, there will be no screws, you will have to get the screws you need depth wise for your specific project. Nice bolt has heavy threading as you can see very nice quality here. Thanks for shopping with us, please check our store for more wonderful pieces of hardware.
See my Store: East End Antiques